Análisis del oleaje máximo generado por el posible colapso de una masa inestable en el lago de la Presa Potrerillos (Prov. Mendoza)
; Moreiras, Stella Maris 
Otros responsables
Fecha
12/2015
Editorial
ASAGAI
Revista
Revista de Geología Aplicada a la Ingeniería y al Ambiente
Título del libro
Nombre del evento
Fecha del evento
Institución organizadora
ISSN
2422-5703
eISSN
1851-7838
ISBN
Idioma
Español
Tipo del evento
Clasificación temática
Palabras clave
Resumen
En este trabajo se estima la altura máxima hipotética del oleaje que se produciría sobre la superficie de agua del embalse Potrerillos, debido al colapso repentino de un deslizamiento situado al pie de la ladera occidental del cerro Los Baños, en la margen nororiental del embalse, calculado en 493.000 m3 aproximadamente. El cálculo de la ola se realiza en base al modelado del área inestable aflorante por encima de la superficie del lago, a través de la selección de la superficie de rotura teórica con menor factor de seguridad. Se asume que el deslizamiento es homogéneo y de geometría triangular simétrica. A partir del cálculo de la amplitud de la onda inicial y final en el agua, generada por la masa que se desliza sobre un plano inclinado, sin rozamiento, considerando las características topográficas del área inestable, se estima que se generaría una altura de ola de 12,90 m en el primer instante y en el sector de ingreso de la masa rocosa al agua. A medida que la onda superficial de gravedad se propaga sin pérdida de energía, llegaría a tener una altura máxima de 3,60 m tanto en la presa como en la costa opuesta, ambos situados a unos 2500 m del deslizamiento. En una situación real de un deslizamiento con rozamiento, se considera que la ola máxima estaría por debajo del nivel de coronamiento de la presa, representando un riesgo bajo hacia la misma.
The hypothetical maximum height of the wave produced on the water surface of Potrerillos dam due to the sudden collapse of a landslide at the western slope foot of Los Baños hill on the dam northeastern margin is estimated on approximately 493.000 m3. The wave calculation is done based on the modeling of the unstable area appearing on the lake surface, through the selection of the desired fracture surface with the lowest safety factor. The landslide is assumed to be homogeneous and with symmetric triangular geometry. Considering the amplitude of the initial and end waves in the water, generated by the rocky mass sliding on an inclined plane without friction, and the topographic features of the unstable area, a 12,90-metre wave is estimated to be generated at the first moment and in the area of the rocky mass entry to water. As the gravity surface wave propagates without energy loss, the wave might reach a maximum height of 3,60 m in the dam and in the opposing coast, both located at 2.500 m from the landslide. In a real landslide situation with friction, the maximum wave is considered to be below the level of the dam crown, representing a low risk to the wave.
The hypothetical maximum height of the wave produced on the water surface of Potrerillos dam due to the sudden collapse of a landslide at the western slope foot of Los Baños hill on the dam northeastern margin is estimated on approximately 493.000 m3. The wave calculation is done based on the modeling of the unstable area appearing on the lake surface, through the selection of the desired fracture surface with the lowest safety factor. The landslide is assumed to be homogeneous and with symmetric triangular geometry. Considering the amplitude of the initial and end waves in the water, generated by the rocky mass sliding on an inclined plane without friction, and the topographic features of the unstable area, a 12,90-metre wave is estimated to be generated at the first moment and in the area of the rocky mass entry to water. As the gravity surface wave propagates without energy loss, the wave might reach a maximum height of 3,60 m in the dam and in the opposing coast, both located at 2.500 m from the landslide. In a real landslide situation with friction, the maximum wave is considered to be below the level of the dam crown, representing a low risk to the wave.
Colecciones
Aprobación
Revisión
Complementado por
Referenciado por
Licencia Creative Commons
Excepto donde se indique lo contrario, la licencia de este ítem se describe como by-nc-sa
