Diffusion controlled LHHW kinetics. Simultaneous determination of chemical kinetic and equilibrium adsorption constants by using the Weisz-Prater approach
; Bidabehere, Claudia María ; Sedran, Ulises Anselmo 
Otros responsables
Fecha
11/2017
Editorial
Pergamon-Elsevier Science Ltd
Revista
Chemical Engineering Science
Título del libro
Nombre del evento
Fecha del evento
Institución organizadora
ISSN
0009-2509
eISSN
ISBN
Idioma
Inglés
Tipo del evento
Clasificación temática
Palabras clave
Resumen
A method to simultaneously determine the chemical kinetics (kCT) and Langmuir’s adsorption equilibrium (KL) constants in porous catalyst particles where chemical reactions following Langmuir-Hinshel wood-Hougen-Watson (LHHW) kinetics (first order on the concentration of the adsorbed species) proceed under the existence of diffusion mass transfer limitations was proposed. Two parameters characterize this steady state diffusion-adsorption-reaction system: the well known Thiele modulus / and the dimensionless adsorption equilibrium constant K, which is defined as the product between KL and the fluid phase concentration of the reactant (Cf). It was shown that the non-linear adsorption equilibrium is the reason that, given /, the larger the K, the flatter the concentration profile and, consequently, the volume average chemical reaction rate and the effectiveness factor are higher. Although the Weisz- Prater (W-P) criterion has been previously extended to non-linear kinetics to evaluate the relative magnitude of diffusion limitations inside porous catalyst particles, this method allows determining the kinetic and adsorption parameters by using the W-P parameter, as assessed from a few laboratory experiments. Differently from the classical W-P criterion (first order kinetics), a single value of W-P parameter below which the chemical control could be secured does not exist for LHHW kinetics. Those ‘‘limit” values depend on K and increase with it. The fact that / is independent from Cf , while K certainly depends on it, makes it easier to simultaneously determine KL and kCT under reaction conditions. When K is small (e.g., lower than 0.1), the model converges to the solutions typical in textbooks, where linear adsorption equilibrium is taken into account, which under steady state conditions only allow estimating the kCTKL product, but not the individual constants.
Colecciones
Aprobación
Revisión
Complementado por
Referenciado por
Licencia Creative Commons
Excepto donde se indique lo contrario, la licencia de este ítem se describe como by-nc-sa
