Artículo

Depth Analysis of Chemical Environments using Resonant Raman Spectroscopy in Total Reflection Geometry

Leani, Juan Jose Icon; Sánchez, H. J. ; Pérez, R. D. ; Pérez, C. A.

Otros responsables

Fecha

06/2010

Editorial

Brazilian Association for Synchrotron Light Technology

Revista

Activity Report

Título del libro

Nombre del evento

Fecha del evento

Institución organizadora

ISSN

1518-0204

eISSN

ISBN

Idioma

Inglés

Tipo del evento

Resumen

Total Reflection of X-rays is a largely proved spectroscopic technique that allows the study of material surfaces. As the refractive index is less than unity, X-rays incident on a material are, theoretically, totally reflected if the glancing angle is less than a critical angle derived from the Snell´s law [1]. Making use of this phenomenon, different depths of a sample surface could be studied by means of the correct election of the incident radiation angle. In this way, analysis of the re- flected intensity could provide a method for studying surface properties, as variations of electron density with depth (e.g., corrosion, porosity, aging, etc.) with a resolution from Amstrongs to hundred nanometers deep [2]. X-ray resonant Raman scattering (RRS) is an inelastic scattering process which presents fundamental differences compared to other scattering interactions between X-rays and atoms; when the energy of the incident photon approaches from below to an absorption edge of the target element, a strong resonant behavior takes place. Both total reflection and resonant Raman scattering techniques are used combined with the aim of discriminate oxidation states in nano-layers of materials. Samples of pure Cu and Fe oxidized in water and salty water, respectively, were studied in the Brazilian synchrotron using monochromatic radiation and an energy dispersive setup. The measurement were carried out in total reflection geometry scanning the incident radiation angle around the critical angle with incident energy lower and close to the K absorption edge of both elements in order to study the RRS emissions. The results not only allowed to observe the presence of very thin oxides, invisible with the use of conventional irradiation geometries, but besides they permit the identification of the oxidation state present in a particular depth of the sample with nanometric resolution, or even Åmstrongs, using a low-resolution system.

Aprobación

Revisión

Complementado por

Referenciado por

Licencia Creative Commons

Excepto donde se indique lo contrario, la licencia de este ítem se describe como by-nc-sa