Influence of Oxygen Carrier on the Autothermicity of a Chemical-Looping Reforming Process for Hydrogen Production
; Volpe Giangiordano, María Florencia
; Suarez, Felipe ; Perez, Federico Martín
; Gatti, Martin Nicolas
; Santori, Gerardo Fabian
; Pompeo, Francisco 
Otros responsables
Fecha
01/2025
Editorial
Multidisciplinary Digital Publishing Institute
Revista
Reactions
Título del libro
Nombre del evento
Fecha del evento
Institución organizadora
ISSN
eISSN
2624-781X
ISBN
Idioma
Inglés
Tipo del evento
Clasificación temática
Palabras clave
Resumen
The chemical-looping reforming (CLR) of methane for hydrogen production employs a solid oxygen carrier (OC) and combines endothermic and exothermic stages, allowing for potential autothermal operation. This study conducted a thermodynamic analysis using Gibbs free energy minimization and energy balances to assess the behavior of WO3, MnWO4, and NiWO4 as OCs in the CLR process. The effects of CH4:OC ratios and reactor temperatures on equilibrium composition and the energy performance were examined. The results demonstrated that elevated reduction temperatures promote OC conversion and the formation of more reduced solid products. Molar ratios above stoichiometric prevent carbon formation, whereas stoichiometric ratios result in higher H2 yield, achieving 98% at 1000 ◦C. However, these conditions do not support autothermal operation, which requires CH4:OC molar ratios above stoichiometric. Additionally, lower oxidation temperatures are preferred regardless of the OC, due to the lower heat needed to preheat the air, which has a greater effect on the net heat. For the reduction temperature, its effect depends on the type of OC analyzed. The maximum H2 yield obtained under autothermal operation was 88% for the three OCs, at 875 ◦C for MnWO4 and 775 ◦C for both WO3 and NiWO4.
Colecciones
Aprobación
Revisión
Complementado por
Referenciado por
Licencia Creative Commons
Excepto donde se indique lo contrario, la licencia de este ítem se describe como by
