<link rel="stylesheet" href="/res/styles.39be4579664c3a48.css">
Artículo

Undercut tolerances in industry from a fracture mechanic perspective

Steimbreger, Ceferino Icon; Chapetti, Mirco Daniel Icon

Otros responsables

Fecha

05/2018

Editorial

EDP Sciences

Revista

MATEC Web of Conferences

Título del libro

Nombre del evento

Fecha del evento

Institución organizadora

ISSN

2261-236X

eISSN

ISBN

Idioma

Inglés

Tipo del evento

Clasificación temática

Resumen

Fatigue is an important damage mechanism that particularly affects welded components, since they are likely to present residual stresses, inhomogeneities and stress raisers. Assessment of cyclic load effects on welds has concerned both industries and scientist for decades; unexpected failure must be prevented and at the same time, structures must withstand design loads with minimum requirements of material. All these facts together with economic issues have lead to the creation of normative that rule designing and construction of welded components. Particularly, toe undercuts are generally found in large structures, and large scatter and disagreement exists towards their significance and effects. Documents usually limit only their depth without considering radius, width or length, and there is currently no explanation to that fact. Understanding the damaging process will also help to set less conservative tolerances, with consequent cost reduction due to less demanding inspection. The present paper deals with a fracture mechanic approach that uses the Resistance Curve concept to predict fatigue limit of welded components with undercuts. Results revealed that depth is the most influencing variable, and it can be used as the limiting parameter in design regulations. Moreover, good correlation was obtained with FAT values normally assigned to this kind of defect.

Aprobación

Revisión

Complementado por

Referenciado por

Licencia Creative Commons

Excepto donde se indique lo contrario, la licencia de este ítem se describe como by-nc-sa