Repositorio Institucional
Repositorio Institucional
CONICET Digital
  • Inicio
  • EXPLORAR
    • AUTORES
    • DISCIPLINAS
    • COMUNIDADES
  • Estadísticas
  • Novedades
    • Noticias
    • Boletines
  • Ayuda
    • General
    • Datos de investigación
  • Acerca de
    • CONICET Digital
    • Equipo
    • Red Federal
  • Contacto
JavaScript is disabled for your browser. Some features of this site may not work without it.
  • INFORMACIÓN GENERAL
  • RESUMEN
  • ESTADISTICAS
 
Artículo

Kinetic modeling of the liquid-phase hydrogenation of cinnamaldehyde on copper-based catalysts

Marchi, Alberto JulioIcon ; París, José Antonio; Bertero, Nicolas MaximilianoIcon ; Apesteguia, Carlos RodolfoIcon
Fecha de publicación: 11/2007
Editorial: American Chemical Society
Revista: Industrial & Engineering Chemical Research
ISSN: 0888-5885
Idioma: Inglés
Tipo de recurso: Artículo publicado
Clasificación temática:
Otras Ingeniería Química

Resumen

The liquid-phase hydrogenation of cinnamaldehyde (CAL) on copper-based catalysts was studied using pseudo-homogeneous and heterogeneous Langmuir-Hinshelwood-Hougen-Watson (LHHW) kinetics. Three catalysts were used: Cu/SiO2, which was prepared via incipient wetness impregnation, and Cu-Al and Cu-Zn-Al, which were obtained by coprecipitation. The pattern observed for the activity and selectivity to cinnamyl alcohol (COL) was as follows: Cu-Zn-Al > Cu-Al > Cu/SiO2. The best fitting, using LHHW models, was obtained, in all the cases, by assuming total surface coverage. However, and consistent with pseudo-homogeneous analysis, the best fitting for the Cu/SiO2 and Cu-Al was achieved by considering that CAL is much more strongly adsorbed than products on metal copper sites to yield essentially hydrocinnamaldehyde (HCAL). In contrast, the best fitting for the Cu-Zn-Al catalyst was obtained by considering that (i) the adsorption strength values of CAL, HCAL, and COL on the catalyst surface are similar; and (ii) CAL is adsorbed on two different types of active sites (specifically, CAL adsorbs on Cu 0 to form HCAL and on the Cu-Zn2+ interface sites to produce essentially COL). The modeling of catalytic data using LHHW kinetics and the estimated parameters allowed for interpretation of the reasons for the higher COL formation rate observed on Cu-Zn-Al catalyst, in comparison to Cu/SiO2 and Cu-Al catalysts. © 2007 American Chemical Society.
Palabras clave: Cinnamaldehyde , Cinnamyl Alcohol , Hydrogenation , Kinetic Modeling
Ver el registro completo
 
Archivos asociados
Thumbnail
 
Tamaño: 145.9Kb
Formato: PDF
.
Descargar
Licencia
info:eu-repo/semantics/openAccess Excepto donde se diga explícitamente, este item se publica bajo la siguiente descripción: Creative Commons Attribution-NonCommercial-ShareAlike 2.5 Unported (CC BY-NC-SA 2.5)
Identificadores
URI: http://hdl.handle.net/11336/65887
URL: https://pubs.acs.org/doi/10.1021/ie070305n
DOI: http://dx.doi.org/10.1021/ie070305n
Colecciones
Articulos(INCAPE)
Articulos de INST.DE INVEST.EN CATALISIS Y PETROQUIMICA "ING. JOSE MIGUEL PARERA"
Citación
Marchi, Alberto Julio; París, José Antonio; Bertero, Nicolas Maximiliano; Apesteguia, Carlos Rodolfo; Kinetic modeling of the liquid-phase hydrogenation of cinnamaldehyde on copper-based catalysts; American Chemical Society; Industrial & Engineering Chemical Research; 46; 23; 11-2007; 7657-7666
Compartir
Altmétricas
 

Enviar por e-mail
Separar cada destinatario (hasta 5) con punto y coma.
  • Facebook
  • X Conicet Digital
  • Instagram
  • YouTube
  • Sound Cloud
  • LinkedIn

Los contenidos del CONICET están licenciados bajo Creative Commons Reconocimiento 2.5 Argentina License

https://www.conicet.gov.ar/ - CONICET

Inicio

Explorar

  • Autores
  • Disciplinas
  • Comunidades

Estadísticas

Novedades

  • Noticias
  • Boletines

Ayuda

Acerca de

  • CONICET Digital
  • Equipo
  • Red Federal

Contacto

Godoy Cruz 2290 (C1425FQB) CABA – República Argentina – Tel: +5411 4899-5400 repositorio@conicet.gov.ar
TÉRMINOS Y CONDICIONES