Mostrar el registro sencillo del ítem

dc.contributor.author
Balbi, Marcela Ángela  
dc.contributor.author
Hereñu, Silvina Andrea Noemi  
dc.contributor.author
Proriol Serre, I.  
dc.contributor.author
Vogt, J. B.  
dc.contributor.author
Armas, A. F.  
dc.contributor.author
Alvarez Armas, I.  
dc.date.available
2017-03-22T19:05:27Z  
dc.date.issued
2011-08  
dc.identifier.citation
Balbi, Marcela Ángela; Hereñu, Silvina Andrea Noemi; Proriol Serre, I.; Vogt, J. B.; Armas, A. F.; et al.; Initiation and growth of short cracks during cycling in an aged superduplex stainless steel; Trans Tech Publications; Key Engineering Materials; 465; 8-2011; 411-414  
dc.identifier.issn
1013-9826  
dc.identifier.uri
http://hdl.handle.net/11336/14194  
dc.description.abstract
The kinetics of short crack growth during cycling has been studied in a superduplex stainless steel in aged condition. After few cycles, slip lines appear distributed in both phases but the preferred phase for microcrack nucleation is the ferrite. Contrary to the exponential behavior observed in the as-received material, the growth rate of microcracks in aged condition follows a rather linear law. Internal dislocation structures were studied in the near surface region; microbands that sometimes extend over several grains were found at approximately 45º of the tensile axis on ferrite grains. The origin of the microbands has been analyzed and correlated with the microcracks.  
dc.format
application/pdf  
dc.language.iso
eng  
dc.publisher
Trans Tech Publications  
dc.rights
info:eu-repo/semantics/openAccess  
dc.rights.uri
https://creativecommons.org/licenses/by-nc-sa/2.5/ar/  
dc.subject
Low Cycle Fatigue  
dc.subject
Duplex Stainless Steel  
dc.subject
Short Crack Initiation And Propagation  
dc.subject
Aged Material  
dc.subject.classification
Ingeniería de los Materiales  
dc.subject.classification
Ingeniería de los Materiales  
dc.subject.classification
INGENIERÍAS Y TECNOLOGÍAS  
dc.title
Initiation and growth of short cracks during cycling in an aged superduplex stainless steel  
dc.type
info:eu-repo/semantics/article  
dc.type
info:ar-repo/semantics/artículo  
dc.type
info:eu-repo/semantics/publishedVersion  
dc.date.updated
2017-02-06T14:31:01Z  
dc.journal.volume
465  
dc.journal.pagination
411-414  
dc.journal.pais
Suiza  
dc.journal.ciudad
Zurich  
dc.description.fil
Fil: Balbi, Marcela Ángela. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Rosario. Instituto de Física de Rosario (i); Argentina  
dc.description.fil
Fil: Hereñu, Silvina Andrea Noemi. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Rosario. Instituto de Física de Rosario (i); Argentina  
dc.description.fil
Fil: Proriol Serre, I.. Université de Lille; Francia  
dc.description.fil
Fil: Vogt, J. B.. Université de Lille; Francia  
dc.description.fil
Fil: Armas, A. F.. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Rosario. Instituto de Física de Rosario (i); Argentina  
dc.description.fil
Fil: Alvarez Armas, I.. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Rosario. Instituto de Física de Rosario (i); Argentina  
dc.journal.title
Key Engineering Materials  
dc.relation.alternativeid
info:eu-repo/semantics/altIdentifier/url/https://www.scientific.net/KEM.465.411  
dc.relation.alternativeid
info:eu-repo/semantics/altIdentifier/url/http://dx.doi.org/10.4028/www.scientific.net/KEM.465.411